TrueSpindle PostA post for any machine, from any CAM software.
Mills, lathes, 5-axis, right angle heads: TrueSpindle Post turns your CAM output into proven NC code for each of your machines. Adding or changing a machine never means new software.
How it is built
NC output is safety-critical, so the post is built with rules that make every change visible and tested.
- Each machine set up on its own, so a change to one never touches another
- Every machine's output checked against approved sample programs
- Output only changes when you approve the new sample
- Rounding done one way everywhere, so the same move always posts the same
- Units carried with every value, never assumed
What comes with it
Everything a post should do, without the change fees.
- Header information filled in automatically
- 5-axis tool center point modes and rotary solutions
- Right angle heads and new machines without outside change fees
- Export, post, and simulation run in one click
Questions
Which CAM software does it work with?
Any. We make posts for any machine from any CAM software's tool path output.
Can it handle right angle heads?
Yes. Right angle heads are set up per machine, with the same head angle checks the editor runs.
What does adding a machine cost?
A new machine is set up from its own settings, not new software, so there are no outside change fees. Tell us the machine and control.
Replacing your current post?
Tell us the machines and controls you run and what your post costs you in changes today.